Probably not sturdy enough for what you need, but called to mind a project I needed for a Christmas play in 2003. The setting for the play was in an over full garage used as storage for Christmas decorations. Early in the play the garage door had to open (but did not have to close as part of the play). So, I took a carpet or linoleum tube which was about 4" or 5" in diameter which still had the end cores with about a 1" hole. Then I found a wire spool that was about 10" or 12" in diameter, somehow affixed it to one end of the tube, and put 3/4" pipe through each end to serve as the axle. Upright 2x4" were firmly fastened to the meeting room floor for the axle pipes to fit through them. Baler wire was wound around the wire spool in such a manner that when pulled, it wound up the black plastic which served as the garage door. Of course that only had to work two times - for the dress rehearsal and the play presentation - so, like I said not substantial enough for your needs, but maybe some ideas for a stronger construction.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
