I gather that your aluminum door/curtain struts fit into a "C" style channel at each vertical door jamb. If that is the case that it's very similar to what we build for our temporary enclosures. I put 2 pulleys at the top jamb and run the rope to the respective side. Mind you this is for temporary shelter during construction. If I had to do something more permanent I would mount 2 pulleys at the top about 2 feet in from each edge of the door. Mount a double or single pulley at the edge to direct the ropes through and down to your winch. The problem will be that you are bringing, let's say 14 feet (door height), of double rope though that pulley and you do won't want to mount your winch 14 feet below that pulley. 3 to 4 feet will be a good winch height which leaves you with 10 to 11 feet. You could run the double ropes both to the winch after it's run through the double pulley. I don't know if there is a good way to combine the ropes to a single winch line without getting my hands dirty first.
From experience I will say that watch the size of the pulley in relation to the rope. I've done this with a light 1/4" rope and it tends to bind in the pulley or jump out if any slack is encountered.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
