I hope you insulated the perimeter of the slab vertically down at least 2ft. If not, you are just transferring heat into the ground outside. What size tubing did you use ??? should be at least 7/8" for a slab that size and that spacing. It is near imposable to transfer a lot of BTUs through smaller 1/2" pipe, especially the footage you are using. If it is 1/2" tubing there is very little heat transfer at the end of the system loop, unless you have several loops with pumps on each. Recovery time is much longer, but will eventually get to the temp you want. When we were building commercial buildings we had "Radiant Tech" in Vermont design, spec, and supply all our materials. never had a complaint with heating big shops. Once you have the ceiling and interior walls in with proper insulation, you will notice a big difference. Radiant heat doesn't rise to the ceiling like conventional heating systems. It stays in the lower zone close to the floor, up to about 8-9' high. No need to install ceiling fans with radiant floor heat. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
