Posted by Steve@Advance on January 02, 2017 at 04:32:34 from (24.182.105.179):
In Reply to: Electrical Safety posted by Geo-TH,In on January 02, 2017 at 04:16:10:
That 440v hurts, don't it!
I've never grabbed it, but I brushed the back of my finger against it, reaching up inside a spot welder. I thought the area I was reaching into was all control voltage, it wasn't! It burned a small blister on my finger, but the pain was the same as smashing it with a hammer! It hurt and throbbed for hours!
As for trusting a breaker or disconnect, I nearly got in trouble with an old 240v 3 phase disconnect. It had some type of paper/phenolic arms inside that moved the contacts when the lever was pulled. The center arm (high leg of course) was broken, so when the lever was pulled, that leg stayed energized! For whatever reason I decided to take a look, guess it just didn't feel right. Sure enough...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
