Posted by da.bees on December 31, 2016 at 22:06:58 from (68.203.133.191):
In Reply to: Plow Question posted by Steve@Advance on December 31, 2016 at 18:55:35:
The dirt in N.Central Tx is black and shrink's to open cracks when it dry's. I've had pretty good luck letting rippers all the way down on a box blade to break apart ground that hasn't been tilled for a long time,or use a chisel plow. A MF65 will not pull 2 14" moldboards more than 3 inches deep but a disk-plow does much better,that's what farmers around here used in the 40s and 50s on black dirt. The one for her tractor would have 2 disks. If you have or can barrow a chisel or box blade w/rippers you don't need anything else other than a rear tine tiller. Sand doesn't loosen it at all but compost will,lots of compost. Mixing in lots of compost between now and spring will have her ready to plant in 2017. Ask around to see if a tree service will drop a free load of chips at her place for use as mulch around plants.Cover middles with chips to keep down weeds during growing season then plow them under as compost at end of season. If you can get chips and or manure and have a front loader,keep a big pile damp and composting year around. I find a rear tine tiller more useful than a pto driven. A pto tiller work's well to tear ground up the first time each year but you can't get between rows and around plants after that.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
