Good combo. I have a older Marlin 94 in .357 and a three screw Blackhawk to go with it. That's one of my collections: Marlin 94s chambered the same as Blackhawks. Lot's of fun. My rifle cycles .38 special just fine but some do not. Factory .357 ammo will be fine for any of the rifles mentioned but be careful if you reload...don't try to load it hotter. The rifles will have been designed to handle SAAMI maximum. Just be happy with the extra velocity you get from the longer barrel using the slowest appropriate powder loaded no hotter than the manuals suggest. If you find an older Marlin with the Micro Groove barrel, don't be surprised if they do not group well or if the barrel leads up quickly using soft lead bullets. Micro Groove rifling is not as deep as other types and the soft lead bullets often don't grip it as well. Mine shoots hard-cast or jacketed bullets fine but soft lead bullets go all over the place and leave a mess to clean. Same with my set in .41 magnum. If I remember correctly, Marlin started using regular rifling in their "Cowboy" models to help out cowboy action shooters that wanted to use soft lead bullets that were easy on the targets. Good luck hunting for the right combo....that's half the fun.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
