Posted by RodInNS on December 10, 2016 at 07:05:32 from (184.171.194.151):
In Reply to: cheetah air tank posted by 88-1175 on December 09, 2016 at 20:11:09:
If you can buy one for 50-100 bucks as others have suggested, definitely go that route. I made one out of a 20# propane tank..... but the thing with propane is that it makes it's way into every pore of those tanks. Even if it's empty. Even if it's been sitting for an extended period of time.... there will still be enough gas in there to give you a very exciting experience if you pierce it with flame. I washed it out with water, filled it with water then cut it like that. A hole saw would probably be a better fit tho. A 1.5" ball valve is the bare minimum to make those things work if you're trying to inflate truck tires. 2" would be better. I used 1-1/4" and it doesn't work all that well... If you do go welding on a tank I would suggest that you hydro test the tank/welds before using it by filling the tank with water and then pressurizing it. If it does leak or rupture there will be very little stored energy in the tank because it's full of water...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
