Posted by Tom OConnor on December 04, 2016 at 12:38:03 from (68.83.201.202):
In Reply to: Another bin question... posted by Dave H (MI) on December 04, 2016 at 09:06:24:
Dave,
I have built several bins and used a similar approach as to what J.D. suggested except. First I bulldozed off a flat area where I wanted the bin and then I used a ring of the bin for the form plus a three foot additional section so the cement will have a greater circumference than the bin. This extra section will be where you want the discharge auger to extend through the cement. Wipe it with drain oil so the cement does not stick to it and you are home free. In the center I always used a fifty five gallon drum and cut the top out and weld in a six inch piece of channel iron with the 1/2 inch pipe in the center like was suggested. This gives the sweep auger a pit to empty into and a pivot point. Next I would cut an opening in the side near the bottom of the barrel and cement the discharge auger in at a slight angle. Fill in with sand till you get the depth of cement you want, pour the cement and it will be a neat job that will last the rest of your life. Also don't forget to put a little door that you can control from the outside of the bin just inside the walk door down to the auger so that when the grain stops flowing you can unload the grain that is still piled next to the walk door. Hope some of these ideas help. Tom
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
