Posted by notjustair on November 27, 2016 at 06:52:57 from (184.191.48.136):
Another example of lessons hard learned.
I can't tell you how many times I have repaired something in a hurry and thought that it would be so much faster if they would use machine screws in less critical areas. I ate crow this week and I'm still bitter about it.
I had to remove the oil pan on the 35 Chevy grain truck to clean the pickup screen. The engine has to be unbolted and jacked up but that's another bitter story. The oil pan is held on with about 15 flat head machine screws on either side. I was interested when I first found this but learned on reassembly that no matter the magnetic strength of a screwdriver it won't hold well onto a screw that is 80 years old and probably cut rather crudely when new. I've never learned so many new words in one repair. I've also never used the air compressor to blow globs of grease out of my eyes.
The up side - the old girl is back up and running
The down side - I threw a few tantrums and there might be a couple of replacement Phillips screws in there now.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
