Posted by RBoots on November 22, 2016 at 21:13:37 from (173.241.113.102):
In Reply to: Re: No Till discussion posted by JD Seller on November 22, 2016 at 16:55:35:
We no till sometimes if we are getting late in the season for planting due to extra wet conditions. It doesn't work to well for us. Almost everyone that does not till around here works their ground in three year rotations after corn. Work the ground, plant soybeans. Harvest soybeans, no till wheat. No till corn into the wheat stubble. Work the corn stubble and start over again. Have a neighbor that swears by no till, will not work ground, ever. He did a lot of shares for ground, but many people went with someone else after a couple good years, then many years of declining yields. He had one field tiled last year, one that hadn't been fit in 15 years. The soil behind the tile plow looked like it was boulders as a quarry it was packed so hard. But it was only dirt, no rocks. The landowner is a real loyal guy, but he is old school too, and thinks stuff should be turned over very now and then. He used his old field cultivator and dug the heck out of his field that the farmer had no tilled for so long. Looks pretty good this year. Like you say, it works well year after year some places, but where I live, it doesn't. Most agree a 3 year cycle works best around here if that's how you are going to do it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
