Posted by paul on November 14, 2016 at 19:16:04 from (66.60.223.229):
In Reply to: Sitting on my hands.... posted by Dave H (MI) on November 14, 2016 at 14:46:42:
West of me a lot of lavatory piled outside. My elevator filled the outdoor bunker, last year also, they hadn't used it for 5 years previous. I am fortunate my near elevator has a feed mill, they going 50,000 bu a week, so with the big bin, a few small bins, a good sized bean bin, and the 1/2 million bu bunker they can handle some corn.
But it got real slow, by 2:00pm the wet holding bins would get full, then could only dump as fast as the drier dries it. About the speed of a 6 inch auger. When there are 3 semis, and 6 wagons averaging 600bu each, that is aweful slow dumping....
Terribly wet year, pretty big crop somehow. When we could, we buried them in corn. Combines get bigger, wagons get bigger.....
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
