Posted by NCWayne on November 05, 2016 at 23:43:45 from (173.188.169.54):
In Reply to: Electricians???? posted by Goose on November 05, 2016 at 15:06:42:
I've got a propane gap-pak for heat, a propane oven/stove, and a propane dryer. I've got an 8500 watt diesel (2 cyl Lister Petter) and I've run mine for a week, plus when we lost power in a big winter storm.
The only thing I had to do back then was turn the water heater off to insure I didn't draw too much if the well pump kicked on. At the time I had a 1HP pump, but when it blew I replaced it with a 1/2 HP and I shouldn't have to turn anything off now, based on the numbers, but I still do.
During the winter you should be able to run on 8000 to 8500 watts with no problem because all it takes for the heat is to open the gas valve, and a blower.
In the summer time you won't get as lucky because you have the compressor on the A/C drawing a lot more power.
If it was me, I'd check the max amp draw on the stuff drawing the most juice. In other words your HVAC unit, your well, washer and dryer (together or separate}, and the refrigerator.
If you've got any other loads that may be on the large side, I'd check them and allow a bit for them too. Ultimately though it all comes down to exactly how 'comfortable' you want to be when the power goes out.
From experience I'd say the 10,000 watt would be plenty for you. You can't run everything at once, but you should be able to live comfortably with no issues. Too it's not so big that it drinks a lot of gas.
The one thing to make sure if is that it has 220 capability and that it can be split into two 110 circuits.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
