Posted by Gene Davis (Ga.) on November 05, 2016 at 19:46:41 from (98.67.62.173):
In Reply to: Electricians???? posted by Goose on November 05, 2016 at 15:06:42:
Most of the generators sold new now days have an impressive figure for the selling information and on the box. Very few can produce that figure under a continuous daily sustained load. So what you are getting is a momentary surge of that much power but only a sustainable amount of about 60-70% of that figure. They are also noisy 3,600 rpm screamers built with a life expectancy of probably 100 or so hours and then you spend enormous amounts of time trying to find parts or service for them. Ask Mr. Billy Shafer on here about that part of owning a generator.
Find you one of the older Onan, Kohler, Winco or some of the older cast iron monstrosities set up for propane or natural gas or even better the tri-fuel set up and can burn all of the above plus gasoline. The diesel sets are nice and if you have fuel oil heating tanks you can burn that for generating current. Not all are cast iron, some are lighter aluminum. They usually produce their total amperage at 1,800 rpm and are quieter plus they last longer and have less fuel consumption Most of them can carry the advertised load continuously.
I have an older Onan 20 Kw natural gas fueled one with the transfer switch. This will power my whole house and have a little reserve. I have some gas heat and some heat pumps.
I prefer to have a little too much capacity than to have too little. Sure it will burn a little more fuel, but when it is freezing, sleeting and snowing you will feel better about it. Take care of your generator and it will take care of you when you need it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
