Posted by Dave H (MI) on November 05, 2016 at 07:34:32 from (50.108.25.68):
In Reply to: Corn storage posted by picassomcp on November 05, 2016 at 07:03:19:
Not going to pretend to be a corn storage expert. Only grown it in quantity three years and I bank most of it at the elevator because I don't want bins and a dryer...or the risk. I have a screw in fan I bought at an auction. Around here they go for about $100 used. They are around $500 new I think. Not sure if they do much good. Last year I left about 12" of corn in the bottom of the grain truck with a wood floor. Kept it inside, open top. Turned it with a scoop every week to ten days. Was 16% going in. Kept well until Spring, but winter was cold. When temps rose it got some surface mold but I started turning it more often and it stayed good enough to use all summer. Given your inexperience and the difficulties of drying with a fan only and based on a lot of research and questions I asked on forums I would suggest maybe leave it standing until the elevator can take it. Wildlife takes a toll but I left corn out in the field until late January last year and did well with it. Just some thoughts. The experts will tell you better. Even at today's prices, moldy corn in a bin can mean a big loss.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
