Posted by Billy NY on November 04, 2016 at 17:54:18 from (74.76.4.60):
In Reply to: Wood splitter posted by john achmann on November 04, 2016 at 15:57:05:
To me, it makes a difference, but there certainly is no wrong way just the same.
I like the wedge on the end of the cylinder piston for a few reasons. One is that I can rotate a log and align any natural checking to the wedge, more so on larger more difficult pieces. It makes a difference and I do process lots of elm where this makes it much easier, takes a bit longer, but elm is good firewood. Another is by chance you do get one jammed onto the wedge, on many brands of splitters there are gussets attached to the beam that will push the log off the wedge. It happens sometimes, even with pine and willow from my experience. The 28 ton huskee I'm using seems to split just about anything, but there are some exceptions on occasion. I like dealing with some of the gnarly stuff, often times its dense and makes nice late night pieces to use in a wood stove. A common splitter similar to the huskee/speeco is ideal for wood that is not processor or wedge on beam friendly. One pet peeve is any of these types needs a log cradle on one side minimum, just the beam does not cut it for me.
For straighter and more common size logs, where you can get faster production, beam on the wedge shines, and Loren's set up exhibits that perfectly. Buck your logs and push em through, preferably onto a table just beyond the wedge or conveyor to something that will hold your fire wood.
The difference is what kind of wood you will process.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
