Posted by Destroked 450 on October 27, 2016 at 07:36:24 from (173.242.142.14):
In Reply to: Barn lighting posted by Dave H (MI) on October 25, 2016 at 17:30:46:
I'd go with 2 or 4 tube cold start 4 ft fluorescent light fixtures for low cost and replace them with led strip lights in the same fixtures when the others start going out. We've had some ballast issues with some of the 6 tube fixtures we're using.
No matter what lights you end up with get day light bulbs, they put out better lighting than the standard soft white bulbs.
We started out using 100 watt incandescent bulbs in our poultry barns and went thru over 10 cases of bulbs in 4 years.
We changed to 26 watt cfl's lowering the electric bill over $100 per month and have changed out less than 2 cases of bulbs in 5 years.
In the last year we've tried a few of the newer style 12 watt LED's that give off better light and are preparing to change over to the LED's, should see a small decrease in utility bill but will have better control over light dimming and have better lighting for clean out work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.