Posted by Geo-TH,In on October 17, 2016 at 12:10:13 from (172.78.56.250):
In Reply to: Re: Stump grinding posted by BarnyardEngineering on October 17, 2016 at 05:37:17:
OK you dig a big stump out, then what? Where are you going to put it. Where are you going to get the dirt? A raised 8 sided flower bed isn't the same as going around a smaller tree and getting smacked with branches.
I had a cherry tree blow down exposing the roots. I dug it out, cut all the roots. The roots ball was about 15 ft in diameter. A man with a large skidder couldn't even lift it. I used my backhoe and dug the largest hole in front of the root ball as I could make then rolled the mess upside down and covered it with dirt.
The way I see it, God put roots in the ground, they can rot there too.
A stump grinder won't fix the problem, when the roots under ground rot, then you will be filling the hole every year.
I prefer stump covers, you can pay to have yours ground. I'm too cheap. geo
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
