Good advice on both sides of the coin so far. Depending on your personal situation, beyond what we know, and anything else about this job you, nor any of us know.......The end result will be your own choice.
If it was me, I'd repair it if for no other reason than as a big 'bird' to all of the other individuals involved. Then again, this is the very reason I work for myself.
That said, as an independent I'm still not immune from problems caused by others........The difference is, you'll get paid to do the job just because you do it. In my case, who do I expect to pay me? Is it the customer, who had the part rebuilt by a third party, because it's a specialized part? The fourth party that tested the pump and said it's OK? The same third party that rebuilt the part, yet claims it's not the problem (even though it's already been off and check again after the first rebuild, and a problem was found...and the problem is still the same now as before, just at a higher pressure)????????????
In the end, I'd be PO'd,if it was me, but my advice would have to be just do it, and be glad to get a pay check...............
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
