Posted by K Effective on October 08, 2016 at 04:23:34 from (162.235.236.141):
In Reply to: Makin' Hay on 20hp... posted by Bill VA on October 08, 2016 at 01:22:25:
Growing up, Grandpa still farmed cooperatively with a couple of neighbors- they shared ownership and use of several implements- the two row corn planter, JD 40 with loader, etc. The next door neighbor Erv had the baler, single row corn picker and pull combine.
We mowed with JD 1010 and three-point mower (#9?), raked with JD rake on steel wheels, then Erv would come over with his MI and NI baler and bale for us. He was a mechanic stationed at the Army Air base at Pearl Harbor during the attack, and could make/repair anything. He had done enough to that MI that it was stronger than many bigger tractors around. He also had a 50NF and AO that some times saw hay work, but usually that MI.
Erv was about 80 and had gotten pretty un-reliable when we lost enough good hay to the weather to pay for two balers of our own. I convinced Grandpa and Dad that we should have our own stuff to be able to get our own hay done on our schedule, not just when Erv could get to it. He used to put our crops ahead of his own, but the old machines just would not cooperate, and he was WAY too stubborn to ask for help.
Things kinda changed after that, I still went over to help him whenever I saw him out working, but I think we kinda ticked him off by not relying on him anymore. At one time, he likely would have sold us his 80 acres, or left it to me when he passed, but that never materialized.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.