Posted by Bob in SD on October 03, 2016 at 12:49:23 from (137.216.208.116):
I have a small (600 foot?) driveway and small barnyard to maintain. I have a 7 foot rear-blade, fairly lightweight, that came with my four-cylinder Ford 4000. The outside of the rear wheels on that tractor are about 6 feet apart, and I'm not sure if it's even still possible to move them. The 7 foot blade is a nice match, even with a slight angle is still covers the tire prints. I need to figure out how to get some weight on it without being in the way when I adjust the blade angle and/or put the blade on and off (right now I can move the blade around by hand, which makes hitching up pretty easy)
I also have a JD 3020, outside of rear wheels about 7 feet apart.
I currently mow and blade with the Ford and use the JD as a loader tractor and for the snowblower (IH-80) in the winter.
My local Runnings has some of these 6 foot box. They seem pretty light, and I'm pretty sure you guys will advise me to look for a used one that is heavier (and there really isn't a rush, so I'm OK with that).
Should I look for a 6 footer for the small tractor or a 7 footer for the bigger tractor? I'm not in love with the JD, but never seem to work up to replacing it (and would probably end up with something just as big anyway). I like the little Ford--if I could have figured out how to put a loader on it I wouldn't have bought the JD, but I also never convince myself to sell the Ford. I like the way the JD moves the snow, but would rather drive the Ford most days.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
