Posted by Bob Bancroft on October 03, 2016 at 04:31:01 from (67.142.162.22):
In Reply to: New Holland TC45D saga posted by George Sayre on October 02, 2016 at 16:57:56:
This may have no bearing on what you're doing. It's my experience. I have a NH TT60A I bought slightly used, to (for shame!) replace one of my antique tractors! Unfortunately they have taken an old, simple, reliable Fiat design and added a bunch of modern electronics. I did buy the expensive repair manual. I was annoyed that it beeped at me if I didn't lock the brakes. I found the beeper up at the right rear top area of the engine, barely accessible under the hood, (as the hood hinges at the rear/lifts up from the front.) I was able to remove the beeper without compromising anything else. As I recall, there were three units there. The major benefit of this project was finding a loose wire in one of the units, as I was playing with things, trying to figure it out. You see, I had a starting problem. Occasionally, it would crank forever, but not fire. I had done everything I could to check out the injector pump/fuel system. The problem was, getting 12V to the pump. Turns out there was a loose wire end- one of those that's supposed to be locked in an insulator end, and plugged into this module. You couldn't see it. Apparently it was just kind of hanging there such that it would usually make contact, but then sometimes not.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
