Posted by paul on September 30, 2016 at 11:05:47 from (76.77.197.114):
In Reply to: mn guys getting nervous? posted by young tractor on September 30, 2016 at 07:54:45:
On the northern edge of the floods, was a lot worse for them.
It is common for me to start harvest on my wife's birthday, which is tomorrow. So we aren't really late yet. We have had some really nice falls in the past decade, so some folk expanded and depend on a long fall, others are just used to it. We are not behind at this point, not at all. Maybe be we are getting an average maker, but at this point it's about normal.
Few bto are taking out corn, I hear some are hauling 30+% moisture corn out of the field. And leaving a whole lot of companion and ruts, even with tracked combines and carts. I'm glad I don't have to do that to get done. Yet anyhow.
My corn tested 22 and 25% hand shelled, add 2 points to that for a wagon full typically. That's a little wet. Beans I have a couple fields really close, most are a week off. But it is so humid, so much moisture in the ground, that it just isn't drying them down either.
Been nice to see the sun 3 out of 4 days, that must be a record for this year. Was very foggy this morning but the sun finally broke through. The grass in the yard is still wet, out in the field it might be dried off but just barely, not any more than just off at one in the afternoon.
Might be a slow fall, but not really out of the normal yet.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
