Well, RedMF, I'll toss my $.02 in here, and I think you can just add those bolts/rod to the stuff you want the shop in town to weld, and take it all in there. Any of the parts that may be load bearing would not be on my list to have welded by a beginner. Too much at risk with a load on the forks to trust that. Plus, you might just ruin enough bolts/rod to pay to have someone do it right the first time. When you start talking about buying a welder, you also need: helmet/gloves/protective clothing/rod/cord/recepticle/wiring/breaker/grinder/hammer/etc, etc.
To save a few bucks getting the job done right? Forget it. You will probably be money ahead hiring it done.
Pros are pros because they know what they are doing and can do it right repeatedly and safely. Take advantage of them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
