Like I said before there is no reason to put a spacer on the shaft between the snap ring and bearing. Just does not make sense. The world just cut the grove over a little. The only logical place to put the spacer is in-between the gear and bearing to take up space to separate the two parts.
I did not notice E-44 when I did the first post. E-44 is a snap ring or what they are calling a retainer ring. I would be willing to bet E-44 and E-45 are the same diameter for the shaft but have a different thickness. E-45 are thick to hold up to use and E-44 is thinner because that much space is not needed. Another possibility is E-45 fits on the shaft and E-44 fits in the housing.
So is there a grove in the shaft or housing where a snap ring would go between the two parts. This would narrow down if it is a snap ring or just a spacer.
Either way you may be making this part. When you do get in touch with Howse you may find that this box is so old they do not support it any longer as I can not find it in their parts listings.
And I will repeat. The only logical place for a spacer is in-between the bearing and the gear. If the spacer went on either end there would be no reason for it. Just move the snap ring grove.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
