Posted by Used red mn on September 02, 2016 at 20:05:04 from (76.113.131.26):
In Reply to: Re: OT: BS engine posted by howdy1960 on September 02, 2016 at 19:05:47:
So if I read your question right and this is what you were actually trying to ask; so here goes. You want to know if it is acceptable for the magnet segment in the flywheel to have continuity (or have contact with) the metallic section of the flywheel? Yes it does have continuity with the flywheel, not sure if it is press fit or uses some other attachment method. In the end it does not matter, the magnet only needs to produce a magnetic field. Then as that field passes a conductor or multiple conductors of the coil primary windings in this case it produces electrical energy. Which according to the B & S website will happen even if the magnet is rusty. I think the poster who shared the polarity may be wrong might have the answer for you of what is keeping your engine from running.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
