Posted by super99 on September 01, 2016 at 18:17:15 from (74.32.249.162):
I have a 400 Farmall with a loader on it. It only gets used for loader work, so it doesn't get many hours on it. I replaced points, condenser and spark plugs last Dec and it started and seemed to run OK. I was trying to move some gravel the other night, and it would start missing under a load, sounded like it was running on 2 cylinders. I just had it at a fast idle and as soon as it got a load on it, it would start missing. Sometimes it would die when opening the throttle and sometimes it would miss and then come out of it. The motor is weak, it likes to foul spark plugs. I put a set of non-foulers on the plugs a few years ago and it helped a lot. I took the plugs out and cleaned them and they were all wet with fuel or oil, no sure which. I still have more to do, guess I'll buy another set of plugs and see if that helps. Any ideas?? Thanks, Chris
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
