Posted by Steve@Advance on August 19, 2016 at 19:35:59 from (107.203.134.67):
In Reply to: Large wood planner posted by jm. on August 19, 2016 at 17:31:44:
Typically, when replacing an electric motor with a gas motor, you use a 2x multiplier. Not sure how that applies to diesel though.
Either way, electric motors make full torque through their entire RPM range, where reciprocating engines fall off as they are loaded to the point they slow from full governed RPM.
So, the 2x factor would work out about right using the 11 HP and slightly overdriving the planner to get the right RPM.
Is the planner still under power? If so, check the loaded amps, see if it is maxing out the motor. If it is staying under the FLA, the 11 HP should be fine. If it is going over the FLA, or would be nice to have more power, go with the 19 HP.
Another factor to consider is how much the planner used. Is fuel economy a concern? If not, go with the larger motor.
Also be sure to check the belt drive requirements. Reciprocating engines require a heavier belt arrangement than electric motors.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
