Posted by Ken Macfarlane on August 19, 2016 at 13:17:00 from (142.166.168.2):
In Reply to: Re: Chain baler posted by Alan K on August 19, 2016 at 06:46:40:
My roller is a MF, that is a rebadged Gehl, which is basically an OMC. First off it is no where near as sensitive to side to side variation. Second, if you do a bad job it hides it by making the core a little softer on the more empty side. If you don't look at that side you wouldn't know you screwed up.
There isn't really anything to look at while baling but if you squint you can see a bit of what is happening. As long as you don't plug the pickup in the first 10 ft or so it never fails to start a bale. The first 3/4 of the bale you can drive as fast as you'd like really. I was hitting 12-15 mph in some 2.5 ton per acre timothy this summer behind a 14 ft rake. The last 1/4 I progressively slow down to really pack the bale. If you don't slow down you get soft bales than don't hold their shape and are a pain to handle later.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
