Permatex Ultra Copper IS THE BEST thing you can put on it BAR NONE.
WHY you say, The gasket is like sand paper over time it eats away at the manifold Over time the RTV will turn back to a powder when that happens it acts as a lubricant between the manifold and block.
It will extend the life of the gasket along with the parts the gasket is mounted to. I have removed N manifolds that were on the tractor 5 years were Ultra Copper was applied on both sides of the gasket. The gasket was still usable :shock: The gasket had a power on it, it looked like pink baby powder. :)
Don't over kill it a thin coating on both sides will do. If you overkill it, it will squeeze out and restrict the intake ports, a N needs all the help it can GIT...
I don't know were the other guys get there reference to not using RTV on a exhaust manifold for sure it does not apply there day job that depends on fixing it one time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
