Posted by crkeesey on August 07, 2016 at 09:39:43 from (198.185.18.207):
Hello everyone. Any guidance appreciated.
I am near the end of a restoration of a '63 JD 1010 Diesel. Ran great before I tore it down to paint. Just reassembled and am unable to get fuel to the injector lines. I verified that I have fuel flow from the tank, fuel to the filter bowl, fuel into the injector pump intake line, I can see the injector pump spins when I take the little timing cover plate off of the front of the pump and there is fuel flowing from there when the cover is off. After that, I get nothing flowing out of the #1 fuel line from the pump and obviously nothing then through the line to the cylinder. What can I check next?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
