Posted by John T PS on July 10, 2016 at 06:05:24 from (216.249.81.101):
In Reply to: Ignition Coil 12 volt posted by gdtractor on July 09, 2016 at 19:48:30:
OOOPS my bad, Before anyone or some Troll has a calf or jumps out of the woodwork yelling GOTCHA I was in a hurry (ITs Sunday morning you know) and made a mistake below
For a 12 volt tractor a 1.4 ohms LV primary coil IS TOO LOW and points would burn up prematurely, an elec switch can handle more coil current. I was hurriedly thinking about a 6 volt system where 1.5 ohms could work. If you used such a coil with an external series voltage dropping (12 to 6) current limiting BALLAST RESISTOR the points wont burn up prematurely but lower current wont yield as much energy either !!!!!!!!!!!!
Sorry about that, so many questions so little time but I try my best to help
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.