Paul meant to say it's a "Sickle Mower" not Suckle Mower. It was used to cut hay. Be careful when moving it or lowering the sickle bar. It can cut your fingers off if you get them in between the sickle guards/points. The mower doesn't have to be moving for this to happen. Just lowering the sickle bar causes the sickle to slide inside the bar. It'll cut more than one finger off at at time.
When I was in high school there was a boy 2 years behind me. He had all his fingers on each hand except his thumbs cut off from one of these sickles. He was just 4 years old when it happened. This is why I say be careful. Always grab the sickle bar from the very end and fingers away from the guards.
It took two good horses to pull one of those thru the alfalfa and clover fields years ago. Since the sickle had to recipricate very fast the gearing had to have a very high gear ratio. This made the mower very hard to pull especially thru thick hay. This is also why the mower is made mainly of cast iron parts. It had to be heavy so the wheels would get good traction due to the gearing of the machine. If the machine wasn't heavy the wheels would just slide over the ground surface.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
