Last winter I put twelve coats of urethane on a kitchen table I made. It was so frustrating trying to get the perfect flawless finish but I did win out. The proper natural bristle brush suggestion is very good advice. What I will add to that is to buy a GOOD EXPENSIVE brush that does not lose bristles, depositing them in the wet finish. For handling the holidays I looked over it very closely using a bright light and reflection immediately after brushing while the urethane was still good and wet so I could re-brush the holidays and still have it blend in. Lots of brush strokes with a wet brush is important. I sanded thoroughly with 2000 grit the next day, then put on another coat. The first couple coats were brushed with a cheaper brush that left bristles in the urethane (Grrr). Then I sprayed on six coats but I wasn't completely satisfied with the results from spraying no matter how far I thinned it. I finally did the last last four coats with a high quality bristle brush using mildly thinned urethane and ended up fairly happy with the results. This was gloss urethane over a large horizontal surface so it was a different ball game compared to semi gloss on window and door woodwork. It seemed to me thinner urethane didn't tend to have as many holidays and holidays will happen in the first or tenth coat or anywhere in between.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
