Posted by John T on June 12, 2016 at 13:45:40 from (216.249.76.23):
In Reply to: Re: GFCI on generator posted by JD Seller on June 12, 2016 at 12:40:13:
Hey dont feel bad or be sorry JD, it takes time for even an electrical engineer to understand all this !!! When I was a farmer and mechanic type before I studied and practiced electrical engineering I likewise didn't get it all either..
SURE, if a genset is configured as a SEPARATE DERIVED SOURCE IT REQUIRES A GROUNDING ELECTRODE
But if NOT and youre tied to a utility the Neutral MUST BE FLOATING
SURE the NEC says if portable gensets feed plug and cord equipment via onboard receptacles NO GROUNDING IS REQUIRED
SURE a manual always states to ground it BECAUSE THEY HAVE TO BE COVERED if its wired as a separate derived source
SURE OSHA can levy fines if its NOT wired per the NEC
Hey if you are okay with a wire being 120 VAC above ground and let your barefoot grandchild touch on wet ground it that's too bad but I prefer a wire with ZERO volts above ground if I had to touch it
You are NOT A hill billy dumb butt as you called yourself in my opinion, I think youre pretty sharp and can NOT be expected to understand what takes years and years of study and experience and practice to understand
DO NOT FEEL BAD youre a good man and different professions have different expertise, just because youre not an electrician or tech or engineer DOES NOT MAKE YOU BAD OR DUMB
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
