dc, if the battery has enough capacity to START the engine, if you're not using lights etc., it should run for HOURSSSSSSS EVEN IF NOT CHARGING WHATSOEVER (coil only draws 4 amps) so I don't see it dying shortly thereafter as caused by non charging.
If its hard to crank after its warmed up, that could be a carboned or loose or resistive cable or ground or connection or a starter motor problem and NOT the battery. After it dies and is hard to crank, will it start okay once it cools down??????????? ORRRRRRRRRR is it necessary to charge the battery before it cranks good?????????????? I would remove, clean and wire brush shiny, then re attach each and every battery and starter and solenoid or switch and ground connection and see if that helps.
Take the battery and have a shop do a free LOAD TEST.
If you want to test the charging system use my Charging Troubleshooting Procedure linked below for a complete and thorough test. Be sure the genny is polarized correct, belt is good n tight, and VR has a good ground.
Try the above and check and clean connections and run my troubleshooting then post back what you find or questions
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
