Posted by Ron-MO on May 16, 2016 at 06:44:40 from (174.131.235.238):
In Reply to: Same thing again! posted by Greg1959 on May 15, 2016 at 18:11:33:
I have been removing the hay from approx. 50 acres of my property for approx. 12 years now. The past 3-4 years the person that was buying it offered to cut, bale and remove for half, then purchase my half at fair market value. I quickly took him up on his offer. While I realize that this is removing a great deal of nutrients off the fields, fertilizing is not in the equation as the cost of the fertilizer is far more than the payback, so as long as he is willing to remove the hay, and I can at least get some payback and pay a portion of my property taxes (not enough income from the hay to pay my taxes thanks to high local school taxes) I will continue to do so. No cattle on the place since 1999. I have considered letting the fields grow one year and brush hog it down in the fall which would help some, but doubt this would offset the loss of the years crop. I did have a similar situation a few years ago on a place I sold, where a guy wanted to "rent" the place, but when I asked how much he was willing to pay, he quickly informed me he would simply "keep the fences repaired". I sent him on his way.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.