Posted by jimg.allentown on May 10, 2016 at 07:18:42 from (108.2.196.109):
In Reply to: OT FORD GEM MODULE posted by lenray on May 09, 2016 at 10:22:32:
The GEM module is actually acting as a body control module. It controls most functions related to the body of the truck - such as windows, wipers, power accessories, etc. As soon as you start trying to hotwire functions of this module, you are asking for trouble. Connect the wrong wire, and you might risk fire or just end up disabling the rest of the functions of this module.
As others have said, you will be better off to replace the module. I can sympathize with the $800 price tag, but there are outfits that refurbish automotive modules for a small fraction of the cost from the dealer. The last one I bought was from an outfit in Florida. $200 for a refurbished Chrysler ECM.
Short of rewiring the entire truck, replacing the module is by far the easiest and most economical repair.
As a side note, this points to why I posted a previous thread about "deal breakers" in newer cars and trucks. They have gone TOO FAR with electronics in vehicles.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
