Posted by Mike M on April 22, 2016 at 07:12:11 from (24.140.3.210):
In Reply to: frount end loader posted by itsb on April 22, 2016 at 06:25:47:
I'm thinking you will need one that starts with 500 series. My 5105 IIRC has a 520 loader on it. When buying a used loader be very careful as to what it came off of so you get all the correct brackets. Missing parts won't be cheap and anymore this stuff gets obsoleted pretty fast. A JD dealer should be able to look back in some old sales manuals and tell what you need. Is your tractor equipped with the mid mounted SCV now ? Won't be cheap but might be better off to get a complete package all new for your machine. One thing I've noticed is these tractors are so much more unstable with a loader than older tractors with loaders I have ran. Must be the short wheel base ,light weight and narrow width ? Make sure you get plenty of counter weight. Plus they lift a lot. Mine will easily lift 3000 lbs. to full height.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
