I watched it slowly work its way across our woods across the road from my house about 6-7 years ago. No real big ash trees over there, so I wasn't terribly worried about them. Really didn't want to see it behind my house though, as I have huge ash trees along the river flats up to about 40" diameter. I started noticing them dying off shortly after it made its way across the woods across the road. Before they went to total waste, I timbered about 45 very large ash trees that had real nice logs, better than turning them into firewood. I still have hundreds of ash trees I've been working at for the last few years, up to about 30". Most sawmills are taking a lot of ash right now, dead trees, before they actually become punky. Most of you know how long they'll last standing, until the roots rot off and they tip over. With that said, if you cut an ash tree, when it starts to get the sucker leaves on the trunk, it will have sucker trees growing from the stump. I'm sort of hoping by continuing to do that, I'll have some left until they figure something out to stop it. If you cut the suckers, I have found they'll sucker off too. I have a few now that are about 4" in diameter. Just a sort of home brew experiment I'm working on, what have I got to lose?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
