Grass clippings from an un-sprayed or treated lawn makes great mulch. I prefer to let mine dry like hay, then collect with a lawn sweeper and use immediately after transplanting. When planting seed, I just leave enough room for the plants to germinate, hand weeding after is easy.
Grass clippings seems to provide a lot of nitrogen if its placed down green like hay. I've isolated corn in marginal soil and piled it up around the corn, the difference is amazing, lush green stalks double ears, go another few feet in that same soil and its a failed crop.
When I could not use my own grass due to time or what have you, I'd just buy hay, a good 2nd cut makes nice mulch, and there is usually no mature weeds in it with seed. Thinking back, hay or straw I've never had any trouble with weeds from it. This mulch will keep the ground moist too, + add organic matter to your soil once tilled in after the season.
A patch that size will require a fair amount, say a dozen bales of hay, but once you plant/transplant, then lay it down, that's it, there is very little weeding to be done with a decent layer of mulch.
One drawback that I think is possible is powder mold, I seem to get it every year on my cucumbers, the mulch will mold once the rain hits it, but I am not sure if its the same mold, just something I am aware of.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
