Neighbor got laid off about 20 years ago, from his truck driving job. He applied for re-training in environmental field- got his full unemployment compensation, plus all tuition and fees paid for 2 years while he went to community college for an AA in Environmental Science. He never did get a job in that field, and eventually went back to truck driving, but had a nice hiatus from work and got to hang around with college kids for a couple of years rather than be at home with SWMBO, which was much more pleasant for him.
It sounds like you'd like to work, and with your credentials, you may just be able to find something, but I agree that at 62, it may be tough. You'll be better off staying on unemployment rather than taking the first low paying thing that comes along. I'd think you could look for work in your field until rocking chair was about to run out, then do the re-training bit. That's going to get you a lot closer to full retirement age. Don't know what your financial circumstances are, but I wouldn't start social security at 62 unless you have a lot of retirement funds socked away. If you're going to depending primarily on Social Security, try as hard as you can to delay taking it until age 66. The reduced amount you'll get at 62 will start looking pretty meager in a few years.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: The People You Buy From - by Chris Pratt. If you are a first-time buyer, chances are that you are likely to take the word of the seller on things. This is where the problems start... You have reviewed your implement needs and determined the size of machine that will fit the bill and even made a list of the most desirable models. You checked on the availability of a 3-point hitch for the machines on the list and advertised in your local classified paper with so
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
