Posted by Bob on March 24, 2016 at 08:40:15 from (64.255.159.192):
In Reply to: 8N hydraulic leak posted by grizzly1 on March 24, 2016 at 08:30:01:
The gasket has blown. There's a passage from the pump up through the body of the tractor, where it matches up to the lift cover, there's a gasket there, as well.
The original gaskets contained asbestos, making them TOUGH.
The politically-correct gaskets sold today are not as tough.
When you replace it, clean surfaces WELL, and don't use sealant, especially silicon, as that makes the gasket slippery and even more prone to blow.
If you are planning to do this, have a service manual at hand and/or ask for details of the job at the "N"-specific Board linked below. The job involves draining the oil, pulling the PTO shaft, and then the pump.
When going back together, the control lever hanging down from the lift mechanism has be engage the control valve in the pump.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
