Dad ran one in his shop for nearly 10 years, and it will burn anything that is compatible with other oils.
In other words, as long as it's all being poured into a large tank, and mixing, it's not going to be an issue.
The only problems we ever had was antifreeze getting in the mix from oil obtained from other people. We all but eliminated that problem by putting the oil a settling tank first, and then transferring it to the larger tank after draining off any contaminates.
Other than occasional maintenance, we never had an issue. The furnace is now in my shop, being readied for next winter. I hope I have the same luck.
One thing to keep in kind if you have one and don't use it all the time. Many of them have heaters in the intake to warm the incoming oil. Depending on the wiring, those heaters will stay on to insure the oil is warm when the furnace comes on. So, if you aren't going to run the furnace for any length of time, insure you have a way to turn things off completely. It might take a bit of warm up before things are optimal but it will prevent the oil in the pre-heat block from getting hot enough to gum up the works.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
