Posted by mj on March 08, 2016 at 23:17:23 from (216.237.90.151):
In Reply to: Gas storage posted by farmallmaniac on March 08, 2016 at 07:51:55:
I got a 'clean' (no fumes) steel 55 gal drum and welded two loops of 1/4" rod to the edge of the top 180 degrees apart (use a chain to unload the full barrel out of my pickup with a FEL). I welded the loops with a MIG so that the top of the drum and the sides are tied together. I take it to the gas station and fill it. When I get it home I put the chain onto the loops and use another chain to hook that chain onto the loader bucket, lift it out and set it on a 4" high platform. I've got a hand pump with a grounded gas hose in the bung hole on the drum to pump the gas out. I always add about 6 ounces of Schaeffer's Nuetra to keep the gas from separating (good old ethanol! :twisted: ) as I may only fill it twice a year.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
