I'm in the process of doing just what you want to do. I am heating the oil then straining it through an old Tee shirt. I know it wil not get the fine stuff out. It will get the course stuff if there is any and will get whatever a cloth will get out. Then the tractor filter will get the rest. We try to keep it clean from beginning to end so there is less problems with dirt. I heat it to about 170 degrees as this will help with the time by getting it done faster. I then take an electric mixxer to check for water in the oil. If it turns milky in the kettle then it goes some more. I just let it set on an electric stove that we use for canning. I get a bout 3 gallon at a time done. I am currently doing the oil in my wetline on the truck. It was looking a bit cloudy and with new seals in the dump trailer I didn't want to have oil with water in the cylinder till fall.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.