Posted by JD Seller on February 25, 2016 at 20:11:25 from (208.126.198.123):
In Reply to: remove manifold bolts posted by howard parker on February 25, 2016 at 18:45:01:
Those bolts are a hard one to get out. I have cut the heads but I usually try heating and wiggling first, second and then maybe cutting the heads off then. I also have had to break the manifold as the bolts can be rusted solid in the manifold too. Usually you can heat the head/bolt after you get the manifold out of the way, and get the bolt to wiggle out. Also the skunk pee of any brand does little to nothing on rusted solid bolts. You have to get them to move some for the liquids to actually do much good.
The air hammer idea can work. I have also hit the top and sides of bolts with just a hammer an punch to shake them some. I have found if your doing this do it DRY first and blow any loosen rust out with compressed air. If you spray it with any type of penetrating oil the rust is caught and you can't blow it out. So I usually start out with them dry and then IF I can get some movement I then use some type of lubricant.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
