You will be fine without coulters. A couple said below the main reason for coulters was to save the leading edge of the moldboard, or shin on newer plows. Plus, it helps make a clean cut for the furrow, thus the reason a lot of people left them on the rear beam. As Delta said, drop it in the ground and have fun.
On another note, if you can take a wire wheel on a grinder and buff up the moldboards first, it will make scouring a whole lot easier. Have fun - Bob
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
