Posted by Bob on February 21, 2016 at 19:19:57 from (64.255.159.192):
In Reply to: Re: thanks everyone posted by J.Wondergem on February 21, 2016 at 18:15:31:
Nope, a mechanical regulator for a generator doesn't "know" what at polarity to charge. That is determined by at what polarity the GENERATOR is "polarized" to BEFORE the system's first startup.
SOME mechanical regulators are marked (+) or (-) ground.
They, too, will work at either polarity, but will LAST LONGER used at intended priority.
This has to do with materials used in the contacts being arranged in opposite configurations for longer life at the polarity a given unit is made to be used with.
As an example, Delco used tungsten for the contact that loses/transfers metal (- side) and platinum for the side that tends to oxidize (+ side). The locations of those contacts would be opposite between a regulator specifically design for (-) ground a nad a regulator specifically designed for (+) ground.
I doubt if any modern units from "The Land of Almost Right" are that well made, though, and are not typically marked as to polarity.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
