Posted by sotxbill on February 15, 2016 at 07:37:57 from (104.5.24.112):
In Reply to: Ratchet strap storage posted by Doug-Iowa on February 15, 2016 at 06:54:58:
I use the clothe / fabric bags that you get at conventions.. They have boat logos, car logos bank logos and health care logos.. You get them at the thrift store for a buck a piece. Each cargo strap goes in a bag and all the strap bags are in one corner of the tool box and all the chains each, go in a bag and are in the other corner of the tool box. Then I simply grab the number of bags I need.... and the use the handles of the bags to tie around the straps and tuck in the excess strap. So the long handles are a plus and I meet txdot requirements by not having more that 3 foot of strap flapping in the wind. ( its a driver distraction) When I unload, I roll each strap up, put in it the bag, and throw the bag back into the bed of the truck... When finished, I simply put all the bags back into the tool box in the proper corner, and lock the box. All the chains and straps stay free of each other and are quick to grab and toss on to the trailer, bag and all, when I get ready to load. Usually a 25k 36' gooseneck, sometimes the 14k 26' gooseneck and occasionally the 16' lowboy. On the light duty truck, I keep the strap bags under the rear seat along with some consumer straps and rope. (lawnmowers, brush, and very small tractors).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
