You didn't do the staple job yourself, did you? Because if you did, you sure did a pretty good job. I tried stapling myself a couple of times because I have all kinds of staple guns, some mechanical (T-50), several using the compressor and I figured that doing myself would have been cheaper than going to the hospital, and it mostly was at first. On the air tank, I probably should have turned down the regulator from 95 lbs because it would have prevented me from having to staple the other side where the first staples went through and came out. And, I probably only should have drank just enough to numb me a little instead of getting to the point where I missed to whole area all together and actually repaired the dog that really didn't need repairing. But after I sobered up, I got it right, after I turned down the regulator to about 24 lbs. As far as the itch goes, I took most of my staples out two years ago but the ones I couldn't get out still itch. I probably should have boiled them and maybe used shorter ones. 3/4 inchers seemed a bit long, but they were the shortest one I had and worked after I bent them over so they quit poking holes through my shirt, pants, and my boots.
Ok, now that I hope that I took your mind off of it...what in the world happened to you? Looks like you're going to be lucky when all is said and done, BUT what in the world did you do that you won't ever do again?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
